Functional Safety Certification for Goods-to-Person Robots: IEC 61496-1 Explained

Date
2027-05-12
Location
Online
Host
Zach L

About this event

A Full-Day Training for Robotics Engineers pursuing functional safety certification. A live 30-minute full-day training on IEC 61496-1 (Electro-Sensitive Protective Equipment) for goods-to-person robots, built for robotics engineers pursuing functional safety certification. What We'll Cover: What IEC 61496-1 (Electro-Sensitive Protective Equipment) requires and how its scope applies to goods-to-person robots Mapping IEC 61496-1 clauses to the certification evidence assessors expect System-specific hazards and safety functions typical of goods-to-person robots Common findings that delay certification, and how to avoid them A practical readiness roadmap for robotics engineers preparing for assessment Related topics: IEC 61496-1 · Goods-to-Person Robots · functional safety certification · fun

Topics

Registration

View event page

About IEC 61496-1 (Electro-Sensitive Protective Equipment)

This training provides practical skills and structured learning on the compliance requirements covered by IEC 61496-1.

IEC 61496-1 gives the general requirements for electro-sensitive protective equipment (ESPE): the functional, design and environmental requirements plus the type classification (Type 2/3/4) that determines which PL/SIL applications a device can serve.

What it regulates

ESPE behavior on detection and on fault, periodic testing, response times, indication, and the type-dependent fault detection requirements; part 1 pairs with technology parts for specific sensing physics.

Who must comply

ESPE manufacturers certifying devices; integrators selecting device Type consistent with the function's PLr.

Key requirements of IEC 61496-1

  • Type 2: fault detection via periodic test — suitable up to PL c applications
  • Type 3: (for AOPDDR, scanners) suitable up to PL d
  • Type 4: continuous self-monitoring — suitable for PL e applications
  • Environmental, EMC and optical immunity requirements
  • Interface behavior: OSSD outputs, restart interlock, muting/blanking hooks

Key concepts: IEC 61496-1

OSSD
Output Signal Switching Device — the monitored solid-state safety outputs pairs with cross-fault detection.
Optical immunity
Resistance to interference from lamps, sunlight, and neighboring ESPE.
Restart interlock
Requirement that after interruption the machine restart only by deliberate command from a position with hazard visibility.
Type vs PL
Device Type constrains the achievable PL of the detection subsystem (Type 2→c, Type 3→d, Type 4→e as typical ceilings).

Frequently asked questions: IEC 61496-1

What do the two OSSD channels provide?

Redundant, monitored outputs with cross-short detection so single wiring faults are revealed — the downstream logic must process both and honor the device's discrepancy behavior.

Can a Type 2 light curtain be used in a PL d function?

Not as the sole detection subsystem — its fault-detection regime typically limits it to PL c. PL d detection generally requires Type 3 (scanners) or Type 4 (curtains) devices.

Standard information based on the published text of IEC 61496-1 (Electro-Sensitive Protective Equipment). Event content is provided by the host. For authoritative guidance, consult the official standard body.